Home › Vehicle Interior › INTERIOR PANELS / TRIM › UPPER INSTRUMENT PANEL › from 2017.06
RM2170E _58 Vehicle Interior _057044 INTERIOR PANELS / TRIM _0278145 UPPER INSTRUMENT PANEL A

INTERIOR PANELS / TRIM  UPPER INSTRUMENT PANEL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL UPPER INSTRUMENT PANEL ASSEMBLY

a.

When using a new instrument panel sub-assembly:

i.

Immediately before installing the upper instrument panel assembly, twist and cut off the portion shown in the illustration.

B301706



b.

Push the upper instrument panel assembly in the direction indicated by the arrow (1) to engage the 5 guides.

B484402N01
5.052,1.698 5.208,1.896 0.156,0.198 10 true 1 4.521,2.208 4.677,2.406 0.156,0.198 10 true 2


c.

Push the upper instrument panel assembly in the direction indicated by the arrow (2) to engage the 7 clips and install the upper instrument panel assembly.


d.

Install the bolt <A>.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


e.

Install the screw <C>.


f.

Install the 2 clips.


Hide 82142A 2.CONNECT NO. 2 INSTRUMENT PANEL WIRE (w/o Occupant Classification System)

Hide 82142A 3.CONNECT NO. 2 INSTRUMENT PANEL WIRE (w/ Occupant Classification System)

Hide 62211 4.INSTALL FRONT PILLAR GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 62311B 5.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

Hide 62212 6.INSTALL FRONT PILLAR GARNISH LH

Hide 62312B 7.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 83100 8.INSTALL COMBINATION METER ASSEMBLY

Hide 55404D 9.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

a.

Engage the 9 guides and 4 claws.


b.

Install the instrument cluster finish panel sub-assembly with the 2 clips.


Hide 55670A 10.INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

a.

Engage the 3 clips to install the center instrument panel register assembly.


Hide 55474B 11.INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH

a.
B484403

Engage the 16 guides and 11 clips to install the instrument cluster finish panel garnish.


Hide 55660 12.INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD)

a.

Engage the 3 clips to install the No. 2 instrument panel register assembly.


Hide 55650 13.INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for RHD)

a.

Engage the 3 clips to install the No. 1 instrument panel register assembly.


Hide 55405B 14.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

a.

Connect the connector.


b.

Engage the 13 clips to install the center instrument cluster finish panel sub-assembly.


Hide 15.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION