Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.REMOVE ROOF HEADLINING ASSEMBLY
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
62180A
4.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY
When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.
When removing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
| *a | Airbag Connector |
| *b | Airbag Connector Locking Button |
| *c | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, release the airbag connector locking button and disconnect the airbag connector.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Using needle nose pliers, remove the 7 pins from the 7 clips (A).
Do not damage the pins.
| *1 | Pin | - | - |
| *a | Clip (A) | *b | Clip (B) |
| *c | Spacer Location | *d | Spacer |
Using 2 screwdrivers, disengage the 2 claws of each clip (A), and separate the 7 clips (A) from the vehicle body as shown in the illustration.
Separate the 7 clips (A) and curtain shield airbag assembly from the vehicle body as a unit.
Disengage the 5 clips (B).
While holding the curtain shield airbag assembly, remove the 2 bolts and curtain shield airbag assembly.
Remove the 7 clips (A) and 3 spacers from the curtain shield airbag assembly.