Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (w/ Removable Headrest) › from 2017.06
RM2170E _58 Vehicle Interior _057040 SEAT _0278111 FRONT SEAT ASSEMBLY(w/ Removable Headrest) A

SEAT  FRONT SEAT ASSEMBLY(w/ Removable Headrest)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:
·

Be sure to read precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).

·

If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.

·

If the front seat airbag sub-assembly was deployed, replace the front seat airbag sub-assembly, separate type front seat cushion spring assembly, separate type front seat cushion pad and separate type front seat cushion cover with the necessary parts in accordance with the extent of the collision damage (w/ Occupant Classification System).



NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 71910A 4.REMOVE FRONT SEAT HEADREST ASSEMBLY

Hide 72124 5.REMOVE FRONT OUTER SEAT TRACK BRACKET COVER (for Cold Area Specification Vehicles)

a.

Lift up the seat track adjusting handle and move the seat to the rearmost position.


b.
B299146

Disengage the 3 claws to remove the front outer seat track bracket cover.


Hide 72128A 6.REMOVE FRONT INNER SEAT TRACK BRACKET COVER (for Cold Area Specification Vehicles)

a.
B299145

Disengage the 2 claws and clip to remove the front inner seat track bracket cover.


Hide 72138J 7.REMOVE REAR OUTER SEAT TRACK BRACKET COVER

a.

Lift up the seat track adjusting handle and move the seat to the foremost position.


b.
B301346

Disengage the 3 claws to remove the rear outer seat track bracket cover.


Hide 8.REMOVE FRONT SEAT ASSEMBLY

a.
B301347

Using a E10 "TORX" socket wrench, remove the 2 bolts on the rear side of the seat.


b.

Lift up the seat track adjusting handle and move the seat to the rearmost position.


c.
B299155

Using a E10 "TORX" socket wrench, remove the 2 bolts on the front side of the seat.


d.

Disconnect each connector and clamp under the seat.


e.

Lift up the seat track adjusting handle and move the seat to the center position. Then, operate the reclining adjuster release handle and move the seatback to the upright position.


f.

Remove the front seat assembly.

NOTICE:

Be careful not to damage the vehicle body.