AIR CONDITIONING AMPLIFIER ASSEMBLY
Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.
| Terminal No.
(Symbol) |
Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G34-1 (IG+) - G34-14 (GND) | V - W-B | Power source (IG) | Power switch on (IG) | 11 to 14 V |
| G34-1 (IG+) - G34-14 (GND) | V - W-B | Power source (IG) | Power switch off | Below 1 V |
| G34-4 (ECOS) - G34-14 (GND) | R - W-B | ECO mode switch (eco switch assembly) signal | Power switch on (IG)
ECO mode switch (eco switch assembly): on |
Below 1 V |
| G34-4 (ECOS) - G34-14 (GND) | R - W-B | ECO mode switch (eco switch assembly) signal | Power switch on (IG)
ECO mode switch (eco switch assembly): off |
11 to 14 V |
| G34-5 (TAM) - G34-13 (SG-2) | W - B | Ambient temperature sensor signal | Power switch on (IG)
Ambient temperature: 25°C (77°F) |
1.8 to 2.2 V |
| G34-5 (TAM) - G34-13 (SG-2) | W - B | Ambient temperature sensor signal | Power switch on (IG)
Ambient temperature: 40°C (104°F) |
0.9 to 1.2 V |
| G34-9 (PRE) - G34-13 (SG-2) | GR - B | Air conditioning pressure sensor signal | Power switch on (READY)
A/C system operating Refrigerant pressure: Abnormal pressure (more than 3025 kPa (30.9 kgf/cm2, 439 psi)) |
4.62 V or higher |
| G34-9 (PRE) - G34-13 (SG-2) | GR - B | Air conditioning pressure sensor signal | Power switch on (READY)
A/C system operating Refrigerant pressure: Abnormal pressure (less than 176 kPa (1.8 kgf/cm2, 25 psi)) |
Below 0.74 V |
| G34-9 (PRE) - G34-13 (SG-2) | GR - B | Air conditioning pressure sensor signal | Power switch on (READY)
A/C system operating Refrigerant pressure: Normal pressure (less than 3025 kPa (30.9 kgf/cm2, 439 psi) and more than 176 kPa (1.8 kgf/cm2, 25 psi)) |
0.74 to 4.62 V |
| G34-10 (S5-3) - G34-13 (SG-2) | Y - B | Power supply for air conditioning pressure sensor | Power switch on (IG) | 4.75 to 5.25 V |
| G34-10 (S5-3) - G34-13 (SG-2) | Y - B | Power supply for air conditioning pressure sensor | Power switch off | Below 1 V |
| G34-11 (CANH) - G34-12 (CANL) | V - W | CAN communication system | CAN communication occurring | Pulse generation |
| G34-13 (SG-2) - Body ground | B - Body ground | Ground for air conditioning pressure sensor, ambient temperature sensor | Always | Below 1 V |
| G34-14 (GND) - Body ground | W-B - Body ground | Ground for main power supply | Always | Below 1 V |
| G34-21 (B) - G34-14 (GND) | BE - W-B | Power source (Back-up) | Power switch off | 11 to 14 V |
| G34-22 (BLW) - G34-14 (GND) | R - W-B | Blower motor speed control signal | Power switch on (IG)
Blower switch: LO |
Pulse generation
(See waveform 1) |
| G34-29 (TR) - G34-34 (SG-1) | P - SB | Room temperature sensor signal | Power switch on (IG)
Cabin temperature: 25°C (77°F) |
1.8 to 2.2 V |
| G34-29 (TR) - G34-34 (SG-1) | P - SB | Room temperature sensor signal | Power switch on (IG)
Cabin temperature: 40°C (104°F) |
1.2 to 1.6 V |
| G34-30 (S5-4) - G34-14 (GND)* | R - W-B | Power supply for solar sensor | Power switch on (IG) | 4.75 to 5.25 V |
| G34-30 (S5-4) - G34-14 (GND)* | R - W-B | Power supply for solar sensor | Power switch off | Below 1 V |
| G34-33 (TS) - G34-14 (GND) | V - W-B | Solar sensor signal | Power switch on (IG)
Solar sensor subjected to electric light |
0.8 to 4.3 V |
| G34-33 (TS) - G34-14 (GND) | V - W-B | Solar sensor signal | Power switch on (IG)
Solar sensor covered with a cloth |
Below 0.8 V |
| G34-34 (SG-1) - Body ground | SB - Body ground | Ground for room temperature sensor | Always | Below 1 V |
| G34-37 (LIN1) - G34-14 (GND) | LG - W-B | LIN communication signal | Power switch on (IG) | Pulse generation |
| z1-2 (BUS G) - Body ground | - | Ground for BUS IC | Always | Below 1 V |
| z1-3 (BUS) - z1-2 (BUS G) | - | BUS IC control signal | Power switch on (IG) | Pulse generation |
| z1-4 (B BUS) - z1-2 (BUS G) | - | Power supply for BUS IC | Power switch off | 11 to 14 V |
| z1-5 (SGA) - Body ground | - | Ground for evaporator temperature sensor | Always | Below 1 V |
| z1-6 (TEA) - z1-5 (SGA) | - | Evaporator temperature sensor signal | Power switch on (IG)
Evaporator temperature: 0°C (32°F) |
2.0 to 2.4 V |
| z1-6 (TEA) - z1-5 (SGA) | - | Evaporator temperature sensor signal | Power switch on (IG)
Evaporator temperature: 15°C (59°F) |
1.4 to 1.8 V |
*: w/o Automatic Light Control
Waveform 1:
| Item | Content |
|---|---|
| Terminal No. | G34-22 (BLW) - G34-14 (GND) |
| Tool Setting | 1 V/DIV., 500 μs/DIV. |
| Vehicle Condition | Power switch on (IG)
Blower switch: LO |
AIR CONDITIONING PANEL (HEATER CONTROL SWITCH BOARD)
Check from the rear of the connector while it is connected to the air conditioning panel (heater control switch board).
| Terminal No.
(Symbol) |
Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G33-2 (LIN1) - Body ground | LG - Body ground | LIN communication signal | Power switch on (IG) | Pulse generation |
| G33-5 (IG+) - G33-8 (GND) | V - W-B | Power source (IG) | Power switch off | Below 1 V |
| G33-5 (IG+) - G33-8 (GND) | V - W-B | Power source (IG) | Power switch on (IG) | 11 to 14 V |
| G33-6 (ILL+) - Body ground | R - Body ground | Illumination signal | Light control switch off | Below 1 V |
| G33-6 (ILL+) - Body ground | R - Body ground | Illumination signal | Light control switch tail or head position | 11 to 14 V |
| G33-7 (ILL-) - Body ground | W - Body ground | Illumination signal | Light control switch off | Below 1 V |
| G33-8 (GND) - Body ground | W-B - Body ground | Ground for air conditioning panel (heater control switch board) | Always | Below 1 V |
HYBRID VEHICLE CONTROL ECU (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>TERMINALS OF ECU)
INVERTER WITH CONVERTER ASSEMBLY (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>TERMINALS OF ECU)