Home › Power Source / Network › 1NZ-FXE BATTERY / CHARGING › AUXILIARY BATTERY › from 2017.06
RM2170E _57 Power Source / Network _057031 1NZ-FXE BATTERY / CHARGING _0278063 AUXILIARY BATTERY A

1NZ-FXE BATTERY / CHARGING  AUXILIARY BATTERY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL AUXILIARY BATTERY

a.

Install the battery insulator to the auxiliary battery.


b.

Install the auxiliary battery to the battery carrier sub-assembly.


c.
A405730

Install the No. 2 battery clamp to the battery carrier sub-assembly with bolt as shown in the illustration.

Torque:
15.1 N*m (154 kgf*cm, 11 ft.*lbf)


d.

Connect the battery hose to the auxiliary battery.


e.

Connect the cable to the positive (+) auxiliary battery terminal and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


f.

Engage the 2 claws to close the battery terminal cap.


Hide 2.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

a.

Connect the cable to the negative (-) auxiliary battery terminal and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION