86011R
1.INSTALL RADIO SETTING CONDENSER
Engage the claw to install a new terminal cover to the wire harness.
Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.
Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.
Do not use excessive force when inserting the wire harness into the terminal cover.
If the terminal cover has been deformed during installation, replace the terminal and terminal cover with new ones.
Engage the 3 claws to install the new terminal cover with wire harness to a new condenser.
Do not use excessive force when inserting the terminal cover into the condenser.
If the terminal cover has been deformed during installation, replace the terminal, terminal cover and condenser with new ones.
Engage the clamp to temporarily install a new radio setting condenser with wire harness.
Install the new radio setting condenser with the bolt.
64740C
2.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
58732C
3.INSTALL REAR ABSORBER CAP LH
81330
4.INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
73370
5.CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH
64716D
6.INSTALL REAR DECK TRIM COVER (w/ Coat Hook)
64716D
7.INSTALL REAR DECK TRIM COVER (w/o Coat Hook)
64330D
8.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
64777J
9.INSTALL SPARE WHEEL CUSHION (w/ Coat Hook)
58570A
10.INSTALL REAR FLOOR MAT ASSEMBLY (w/ Coat Hook)
64997
11.INSTALL DECK FLOOR BOX LH (w/o Coat Hook)
64995
12.INSTALL DECK FLOOR BOX RH (w/o Coat Hook)
Use the same procedure as for the LH side.
58410B
13.INSTALL DECK BOARD ASSEMBLY (w/o Coat Hook)
62332A
14.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
67918A
15.INSTALL REAR DOOR SCUFF PLATE LH
16.INSTALL REAR SEAT CUSHION ASSEMBLY
17.INSTALL REAR SEATBACK ASSEMBLY LH
58167H
18.INSTALL FRONT CENTER FLOOR COVER
58166B
19.INSTALL FRONT FLOOR COVER LH
58165F
20.INSTALL FRONT FLOOR COVER RH
71960B
21.INSTALL REAR CENTER SEAT HEADREST ASSEMBLY
71940A
22.INSTALL REAR SEAT HEADREST ASSEMBLY