71511S
1.INSTALL OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)
Temporarily install the occupant detection sensor (separate type front seat cushion pad).
Using hog ring pliers, install 18 new hog rings.
| *1 | New Hog Ring |
| *2 | Hog Ring Pliers |
Be careful not to damage the separate type front seat cushion cover.
When installing the hog rings, take care to minimize wrinkles as much as possible.
Using hog ring pliers, install the occupant detection sensor (separate type front seat cushion pad) to the separate type front seat cushion cover with 2 new hog rings.
| *1 | New Hog Ring |
| *2 | Hog Ring Pliers |
Be careful not to damage the separate type front seat cushion cover.
When installing the hog rings, take care to minimize wrinkles as much as possible.
2.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (w/ Removable Headrest)>REASSEMBLY
73910A
3.CONNECT FRONT SEAT AIRBAG ASSEMBLY
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (w/ Removable Headrest)>REASSEMBLY
71073S
4.CONNECT SEPARATE TYPE FRONT SEAT BACK COVER
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (w/ Removable Headrest)>REASSEMBLY
71811D
5.INSTALL FRONT SEAT CUSHION SHIELD
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (w/ Removable Headrest)>REASSEMBLY
72525A
6.INSTALL RECLINING ADJUSTER RELEASE HANDLE
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (w/ Removable Headrest)>REASSEMBLY
73230
7.INSTALL FRONT SEAT INNER BELT ASSEMBLY