71940A
1.REMOVE REAR SEAT HEADREST ASSEMBLY
71960B
2.REMOVE REAR CENTER SEAT HEADREST ASSEMBLY
58165F
3.REMOVE FRONT FLOOR COVER RH
58166B
4.REMOVE FRONT FLOOR COVER LH
58167H
5.REMOVE FRONT CENTER FLOOR COVER
6.REMOVE REAR SEATBACK ASSEMBLY RH
7.REMOVE REAR SEAT CUSHION ASSEMBLY
67917A
8.REMOVE REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62331A
9.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
58410B
10.REMOVE DECK BOARD ASSEMBLY (w/o Coat Hook)
64997
11.REMOVE DECK FLOOR BOX LH (w/o Coat Hook)
64995
12.REMOVE DECK FLOOR BOX RH (w/o Coat Hook)
58570A
13.REMOVE REAR FLOOR MAT ASSEMBLY (w/ Coat Hook)
64777J
14.REMOVE SPARE WHEEL CUSHION (w/ Coat Hook)
64330D
15.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
64716D
16.REMOVE REAR DECK TRIM COVER (w/o Coat Hook)
64716D
17.REMOVE REAR DECK TRIM COVER (w/ Coat Hook)
73360
18.DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT BELT>REAR SEAT OUTER BELT ASSEMBLY>REMOVAL
58731C
19.REMOVE REAR ABSORBER CAP RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
64730B
20.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
73350
21.DISCONNECT REAR CENTER SEAT LAP TYPE BELT ASSEMBLY
Using a moulding remover, disengage the 2 claws and open the cover.
Loosen the bolt and disconnect the shoulder anchor of the rear center seat lap type belt assembly.
62471A
22.REMOVE ROOF SIDE INNER GARNISH RH
73350
23.REMOVE REAR CENTER SEAT LAP TYPE BELT ASSEMBLY
Remove the bolt.
Disengage the guide.
Turn the shoulder anchor counterclockwise approximately 90° and pull it out.
Remove the bolt.
Disengage the 2 guides and remove the rear center seat lap type belt assembly.