1. PRECAUTION
G3834
2.REMOVE SERVICE PLUG GRIP
3.REMOVE REAR SEAT CUSHION ASSEMBLY (for Separate Type Seatback)
71033
4.REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY
Remove the 4 bolts and rear seat cushion leg sub-assembly.
G9223
5.REMOVE INVERTER TERMINAL COVER
G9221
6.REMOVE INVERTER COVER
7.CHECK TERMINAL VOLTAGE
G9221
8.INSTALL INVERTER COVER
G9223
9.INSTALL INVERTER TERMINAL COVER
G92F1
10.REMOVE NO. 1 HYBRID BATTERY EXHAUST DUCT
Remove the clip and No. 1 hybrid battery exhaust duct.
11.DISCONNECT WIRE HARNESS
Disconnect the 2 connectors.
Disengage the clamp.
G92T9
12.REMOVE HYBRID BATTERY SERVICE PLUG COVER
Remove the 2 nuts and hybrid battery service plug cover.
G920Q
13.REMOVE NO. 1 HYBRID BATTERY SHIELD SUB-ASSEMBLY
Wear insulated gloves.
Remove the bolt and electric vehicle battery plug as shown in the illustration.
Remove the 2 bolts, 2 nuts and No. 1 hybrid battery shield sub-assembly.
G920C
14.REMOVE NO. 2 HYBRID VEHICLE BATTERY CARRIER BRACKET SUB-ASSEMBLY
Wear insulated gloves.
Disconnect the battery smart unit connector.
Remove the bolt and 2 nuts.
Disengage the 3 clamps and remove the No. 2 hybrid vehicle battery carrier bracket sub-assembly.
89892A
15.REMOVE BATTERY SMART UNIT
Wear insulated gloves.
w/o Wiring Harness Protector:
Disconnect the battery smart unit connector.
Insulate the removed terminals with insulating tape.
Remove the bolt and battery smart unit from the HV battery.
w/ Wiring Harness Protector:
Disengage the 2 claws to remove the wiring harness protector cover from the battery smart unit connector.
Disconnect the battery smart unit connector.
Insulate the removed terminals with insulating tape.
Remove the wiring harness protector from the battery smart unit connector.
Remove the bolt and battery smart unit from the HV battery.