Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › SERVICE PLUG GRIP › from 2017.06
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277936 SERVICE PLUG GRIP A

HYBRID / BATTERY CONTROL  SERVICE PLUG GRIP  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:
·

Before inspecting the high voltage system or disconnecting the low voltage connector of the inverter with converter assembly, take safety precautions such as wearing insulated gloves and removing the service plug grip to prevent electrical shocks. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high voltage system.

·

After removing the service plug grip, wait for at least 10 minutes before touching any of the high voltage connectors or terminals. After waiting for 10 minutes, check the voltage at the terminals in the inspection point in the inverter with converter assembly. The voltage should be 0 V before beginning work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


HINT:

Waiting for at least 10 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.


Hide 58165F 2.REMOVE FRONT FLOOR COVER RH (for Separate Type Seatback)

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 58166B 4.REMOVE FRONT FLOOR COVER LH (for Separate Type Seatback)

Hide 58167H 5.REMOVE FRONT CENTER FLOOR COVER (for Separate Type Seatback)

Hide G3834 6.REMOVE SERVICE PLUG GRIP

CAUTION:
·

Wear insulating gloves.

·

Remove the service plug grip to interrupt the high voltage circuit at the time of inspection or repair.

·

Keep the removed service plug grip in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.

·

All the high voltage wiring connectors are orange.



a.

Wear insulating gloves and remove the service plug grip after sliding up the lever of the service plug grip as shown in the illustration.

A266730

CAUTION:
·

Keep the removed service plug grip in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.

·

After removing the service plug grip, do not touch the high voltage connectors or terminals for 10 minutes.



HINT:

Waiting for at least 10 minutes is required to discharge the high voltage capacitor inside the inverter with converter assembly.