Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › WHEEL OPENING MOULDING(for Rear Side) › from 2018.08
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0364199 WHEEL OPENING MOULDING(for Rear Side) A

EXTERIOR PANELS / TRIM  WHEEL OPENING MOULDING(for Rear Side)  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 76926G 1.REMOVE SIDE MUDGUARD PROTECTOR

a.
B481730

Remove the side mudguard protector.

HINT:
B384421

Do not pull the side mudguard protector to remove it. Push the end of the side mudguard protector to peel it off.



b.

Using non-residue solvent and a cloth, wipe off any side mudguard protector remaining on the quarter outside moulding sub-assembly.


Hide 75602A 2.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY

Hide 76902 3.REMOVE SIDE MUDGUARD SUB-ASSEMBLY

Hide 75862D 4.REMOVE ROCKER PANEL MOULDING RETAINER

a.
B481748

Remove the 2 screws.


b.
B485652

Disengage the 2 clips and remove the rocker panel moulding retainer as shown in the illustration.


Hide 75395A 5.REMOVE NO. 1 OUTSIDE MOULDING CLIP

a.
B485882

Disengage the 2 claws to remove the 2 No. 1 outside moulding clips as shown in the illustration.