Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROCKER PANEL MOULDING › from 2018.08
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0278213 ROCKER PANEL MOULDING A

EXTERIOR PANELS / TRIM  ROCKER PANEL MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75602A 1.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY (w/ Wheel Opening Moulding)

Hide 75606B 2.REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY (w/ Wheel Opening Moulding)

Hide 75852 3.REMOVE ROCKER PANEL MOULDING (w/o Wheel Opening Moulding)

a.
B483234

Using a clip remover, remove the 10 No. 2 side mudguard retainers and rocker panel moulding.


Hide 76902 4.REMOVE SIDE MUDGUARD SUB-ASSEMBLY (w/ Wheel Opening Moulding)

a.
B481735C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the side mudguard sub-assembly as shown in the illustration.


b.
B481736

Remove the screw.


c.
B481737

Using a clip remover, remove the 10 No. 2 side mudguard retainers.


d.
B481738C01
0,0 0,0 false
V100135

Order of Removal


Disengage the 9 clips as shown in the illustration to remove the side mudguard sub-assembly.