Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › WHEEL OPENING MOULDING(for Rear Side) › from 2018.08
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0364199 WHEEL OPENING MOULDING(for Rear Side) A

EXTERIOR PANELS / TRIM  WHEEL OPENING MOULDING(for Rear Side)  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75395A 1.INSTALL NO. 1 OUTSIDE MOULDING CLIP

a.
B485653

Engage the 2 claws to install the 2 No. 1 outside moulding clips as shown in the illustration.


Hide 75862D 2.INSTALL ROCKER PANEL MOULDING RETAINER

a.

Engage the 2 clips to install the rocker panel moulding retainer.


b.

Install the 2 screws.


Hide 76902 3.INSTALL SIDE MUDGUARD SUB-ASSEMBLY

Hide 75602A 4.INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY

Hide 76926G 5.INSTALL SIDE MUDGUARD PROTECTOR

a.

Clean the quarter outside moulding sub-assembly with a non-residue solvent.


b.

Apply primer to the side mudguard protector installation surface of the quarter outside moulding sub-assembly.

NOTICE:
·

Apply the primer evenly so that there are no uncoated areas.


·

Allow the primer to dry for 3 minutes or more.




c.

Remove the release paper from a new side mudguard protector.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.



d.
B481733C01
1.188,1.146 1.344,1.083 1.344,1.083 1.208,1.01 true 2.354,1.115 2.156,1.188 2.156,1.188 2.323,1.052 true 1.365,1 1.542,1.156 0.177,0.156 10 true *a 1.969,1.125 2.146,1.281 0.177,0.156 10 true *a 0.344,0.969 0.5,1.167 0.156,0.198 10 false B 2.958,0.594 3.115,0.792 0.156,0.198 10 false A
*a Line


Install the side mudguard protector as shown in the illustration.

NOTICE:
·

Make sure to press the side mudguard protector firmly to securely install it.

·

If the side mudguard protector is not installed within 24 hours after applying primer, reapply primer before installing it.



Standard Measurement:
Area Measurement
A 1.0 mm (0.0394 in.)
B 3.0 mm (0.118 in.)