When the NE signal is input to the ECM, Tr is turned on, current flows to the coil of the circuit opening relay, the relay switches on, power is supplied to the fuel pump and the fuel pump operates.
While the NE signal is generated (engine running), the ECM keeps Tr on (C/OPN relay on) and the fuel pump also keeps operating.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check whether the fuel pump operation sound occurs when performing the Active Test on the GTS.
Fuel pump operating sound occurs.
OK
NG
Inspect the No. 2 integration relay (C/OPN relay) (See page Engine / Hybrid System>2ZR-FXE (ENGINE CONTROL)>INTEGRATION RELAY>INSPECTION).
OK
NG
Disconnect the ECM connector.
Remove the No. 2 integration relay (C/OPN relay) from the engine room relay block and junction block assembly.
Disconnect the No. 2 integration relay connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1B-7 - A57-8 (FC) | Always | Below 1 Ω |
| 1B-7 or A57-8 (FC) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the No. 2 integration relay (C/OPN relay and IG2 relay) from the engine room relay block and junction block assembly.
Disconnect the No. 2 integration relay connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1B-6 - 1A-4 | Always | Below 1 Ω |
OK
NG
Disconnect the fuel pump connector.
Remove the No. 2 integration relay (C/OPN relay) from the engine room relay block and junction block assembly.
Disconnect the No. 2 integration relay connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1B-8 - R11-4 (B) | Always | Below 1 Ω |
| 1B-8 or R11-4 (B) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the fuel pump connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R11-5 (E) - Body ground | Always | Below 1 Ω |
OK
NG
Inspect the fuel pump (See page Engine / Hybrid System>2ZR-FXE (FUEL)>FUEL PUMP>INSPECTION).
OK
NG
Check the ECM power source circuit (See page Engine / Hybrid System>2ZR-FXE (ENGINE CONTROL)>SFI SYSTEM>ECM Power Source Circuit).
OK
NG