Refer to the Description for DTC P0A80-123 (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>P0A80-123).
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P3011
P3012 P3013 P3014 P3015 P3016 P3017 P3018 |
123 | Presence of a malfunctioning block is determined based on each battery block voltage (1 trip detection). | ·
HV battery ·
Battery smart unit |
P3011-123 to P3018-123 will not be set unless the vehicle is driven for approximately 10 minutes after clearing the DTCs.
In order to ensure HV battery performance, appropriate cooling performance must be maintained. Perform the following items as necessary:
Make sure the air intake port is not blocked.
Make sure there are no gaps between the connecting parts of the ducts.
When disposing of an HV battery, make sure to return it through an authorized collection agent who is capable of handling it safely. If the HV battery is returned via the manufacturer specified route, it will be returned properly and in a safe manner by an authorized collection agent.
Before returning the HV battery, make sure to perform a recovery inspection (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HV BATTERY>RECOVERY INSPECTION)
Make a note of the output DTCs as some of them may be necessary for recovery inspection of the HV battery.
A
B
A
B
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>P0A7F-123
| Result | Proceed to |
|---|---|
| All measured values were within specified range. | A |
| Other than above. | B |
A
B
NEXT