G92D2
1.INSTALL NO. 2 HYBRID BATTERY INTAKE DUCT
Perform this procedure only when replacement of the No. 2 hybrid battery intake duct is necessary.
Install the No. 2 hybrid battery intake duct with the 2 clips.
Install the HV battery (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HV BATTERY>INSTALLATION).
G9230
2.INSTALL BATTERY COOLING BLOWER ASSEMBLY
Be sure not to touch the fan part of the battery cooling blower assembly.
Do not lift the battery cooling blower assembly using the wire harness.
Install the battery cooling blower assembly with the 3 nuts to the battery cooling blower bracket.
Install the battery cooling blower bracket with the 2 bolts.
Connect the connector.
Install the No. 1 hybrid battery intake duct with the 3 clips.
Install the floor carpet.
Install the No.1 rear heater register bezel with the 2 clips.
77306
3.INSTALL FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY (for RHD)
62413A
4.INSTALL CENTER PILLAR LOWER GARNISH RH
Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
62311B
5.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
62331A
6.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
73210
7.CONNECT FRONT SEAT OUTER BELT ASSEMBLY
73233
8.INSTALL LAP BELT OUTER ANCHOR COVER (for RH Side)
Use the same procedure as for the LH side (See page Vehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>INSTALLATION).
67917A
9.INSTALL REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
62111C
10.INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
67913
11.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
12.INSTALL FRONT SEAT ASSEMBLY RH