Home › Engine / Hybrid System › 2ZR-FXE (ENGINE MECHANICAL) › CYLINDER HEAD GASKET
RM2070E _51 Engine / Hybrid System _061907 2ZR-FXE ENGINE MECHANICAL _0301595 CYLINDER HEAD GASKET A

2ZR-FXE ENGINE MECHANICAL  CYLINDER HEAD GASKET  REMOVAL  


PROCEDURE

Hide 11103 1.REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY

Hide 17167 2.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

Hide 13801 5.REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY

Hide 11101 8.REMOVE CYLINDER HEAD SUB-ASSEMBLY

a.
A150891E01
0.583,0.102 0.691,0.253 0.107,0.151 10 3 1.122,0.102 1.229,0.253 0.107,0.151 10 7 1.668,0.115 1.775,0.267 0.107,0.151 10 9 2.2,0.115 2.308,0.267 0.107,0.151 10 6 2.768,0.095 2.875,0.246 0.107,0.151 10 2 0.556,1.784 0.664,1.936 0.107,0.151 10 1 1.095,1.784 1.202,1.936 0.107,0.151 10 5 1.606,1.784 1.797,1.936 0.191,0.151 10 10 2.225,1.784 2.332,1.936 0.107,0.151 10 8 2.775,1.784 2.882,1.936 0.107,0.151 10 4

Using a 10 mm bi-hexagon wrench, uniformly loosen and remove the 10 cylinder head bolts and 10 plate washers in several steps in the sequence shown in the illustration.

NOTICE:
·

Be careful not to drop washers into the cylinder head.

·

Head warpage or cracking could result from removing the bolts in the wrong order.




b.

Using a screwdriver with its tip wrapped with tape, pry between the cylinder head and cylinder block, and remove the cylinder head.

NOTICE:

Be careful not to damage the contact surfaces of the cylinder head and cylinder block.



Hide 11115 9.REMOVE CYLINDER HEAD GASKET

a.
A221761

Remove the cylinder head gasket.