1.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
55736D
2.REMOVE COWL BODY MOUNTING REINFORCEMENT LH (for LHD)
55735C
3.REMOVE COWL BODY MOUNTING REINFORCEMENT RH (for RHD)
55701J
4.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)
55701J
5.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)
11212
6.REMOVE NO. 2 CYLINDER HEAD COVER
58151
7.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
Remove the 3 nuts and front No. 1 floor heat insulator.
51442A
8.REMOVE FRONT NO. 3 ENGINE UNDER COVER
57533B
9.REMOVE FRONT CENTER FLOOR BRACE
10.DRAIN COOLANT (for Engine with Exhaust Heat Recirculation System)
17410
11.REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/ Exhaust Heat Recirculation System)
Perform this procedure when the coolant is not hot.
Disconnect the 3 clamps and heated oxygen sensor connector.
Disconnect the 2 heater water hoses.
Remove the 4 bolts and 4 compression springs.
Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.
Remove the 2 gaskets from the front exhaust pipe assembly and exhaust manifold.
17410
12.REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/o Exhaust Heat Recirculation System)
Remove the 4 bolts and 4 compression springs.
Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.
Remove the 2 gaskets from the front exhaust pipe assembly and exhaust manifold.
58151
13.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
17167
14.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 3 bolts and No. 1 exhaust manifold heat insulator.
89467B
15.REMOVE AIR FUEL RATIO SENSOR
17118
16.REMOVE MANIFOLD STAY
Remove the 3 bolts and manifold stay.
17141
17.REMOVE EXHAUST MANIFOLD
Remove the 7 nuts, exhaust manifold and 2 gaskets.
17168
18.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 3 bolts and No. 2 exhaust manifold heat insulator.