Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2013.08–2014.11
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301640 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  C1A50  Brake System  


DESCRIPTION

When the driving support ECU assembly receives an electronically controlled brake system malfunction signal from the brake booster with master cylinder (skid control ECU) via CAN communication, DTC C1A50 is stored.

DTC No. DTC Detection Condition Trouble Area
C1A50 When signal malfunction from brake booster with master cylinder (skid control ECU) continues for 1 second while dynamic radar cruise control is operating
·

Electronically controlled brake system

·

Driving support ECU assembly



WIRING DIAGRAM

E230010E32
1.292,0.604 1.74,0.771 0.448,0.167 10 false CA1H 1.302,1.115 1.75,1.281 0.448,0.167 10 false CA1L 5.542,0.604 5.99,0.771 0.448,0.167 10 false CA2H 5.542,1.115 5.99,1.281 0.448,0.167 10 false CA2L 3.927,0.604 4.375,0.771 0.448,0.167 10 false CA2H 3.927,1.115 4.375,1.281 0.448,0.167 10 false CA2L 2.979,0.604 3.427,0.771 0.448,0.167 10 false CA1H 2.979,1.115 3.427,1.281 0.448,0.167 10 false CA1L 1.792,0.427 1.99,0.583 0.198,0.156 10 false 37 1.792,0.938 1.99,1.094 0.198,0.156 10 false 38 4.438,0.417 4.635,0.573 0.198,0.156 10 false 34 4.438,0.906 4.635,1.063 0.198,0.156 10 false 35 2.677,0.417 2.875,0.573 0.198,0.156 10 false 25 2.677,0.896 2.875,1.052 0.198,0.156 10 false 24 5.302,0.427 5.5,0.583 0.198,0.156 10 false 39 5.292,0.917 5.49,1.073 0.198,0.156 10 false 17 2.667,0.604 2.885,0.781 0.219,0.177 10 false L6 2.677,1.094 2.896,1.271 0.219,0.177 10 false L6 4.438,0.594 4.656,0.771 0.219,0.177 10 false L5 4.438,1.094 4.656,1.271 0.219,0.177 10 false L5 0.229,1.656 0.5,1.813 0.271,0.156 10 false A58 0.531,1.656 2.292,2.031 1.76,0.375 10 false Brake Booster with Master 3.052,1.698 4.333,2.135 1.281,0.438 10 false Power Management Control ECU 5.385,1.635 5.646,1.823 0.26,0.188 10 false L60 5.656,1.635 7,2 1.344,0.365 10 false Driving Support ECU 0.865,2.302 2.667,2.448 1.802,0.146 10 false : CAN Communication Line

PROCEDURE

1.CHECK FOR DTCs (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.


e.

Check for DTCs.

Result:
Result Proceed to
DTC is not output A
DTC is output B




A

2.CHECK FOR DTCs (DTC C1A50)

B

2.CHECK FOR DTCs (DTC C1A50)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).



d.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed of between approximately 50 km/h (30 mph) and 170 km/h (105 mph).


ii.

Turn the cruise control system on using the cruise control switch (ON-OFF button).


iii.

Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.



e.

Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.


f.

Check for DTCs.

Result:
Result Proceed to
DTC is not output A
DTC C1A50 is output B




A

B

3.REPLACE DRIVING SUPPORT ECU ASSEMBLY
3.REPLACE DRIVING SUPPORT ECU ASSEMBLY
a.

Replace the driving support ECU assembly (See page Engine / Hybrid System>CRUISE CONTROL>DRIVING SUPPORT ECU>REMOVAL).



NEXT

4.CHECK FOR DTCs (DTC C1A50)
4.CHECK FOR DTCs (DTC C1A50)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).



d.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed of between approximately 50 km/h (30 mph) and 170 km/h (105 mph).


ii.

Turn the cruise control system on using the cruise control switch (ON-OFF button).


iii.

Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.



e.

Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.


f.

Check for DTCs.

Result:
Result Proceed to
DTC is not output A
DTC C1A50 is output B




A

END

B

5.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER
5.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER
a.

Replace the brake booster with master cylinder (skid control ECU) (for LHD) (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for LHD)>REMOVAL).


b.

Replace the brake booster with master cylinder (skid control ECU) (for RHD) (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for RHD)>REMOVAL).



NEXT

6.CHECK FOR DTCs (DTC C1A50)
6.CHECK FOR DTCs (DTC C1A50)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).



d.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed of between approximately 50 km/h (30 mph) and 170 km/h (105 mph).


ii.

Turn the cruise control system on using the cruise control switch (ON-OFF button).


iii.

Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.



e.

Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.


f.

Check for DTCs.

Result:
Result Proceed to
DTC is not output A
DTC C1A50 is output B




A

END

B