G1148
1.INSTALL MOTOR CABLE
Wear insulated gloves.
Install the motor cable to the hybrid vehicle transaxle assembly with the 3 bolts.
Keep the sealing surface of the motor cable and the connector terminal joint free of foreign matter.
Engage the 2 claws to install a new terminal cap.
When installing the terminal cap to the motor cable terminal block, keep the sealing surface free of foreign matter.
Place the motor cable connector shell in position and install it with the 2 bolts.
Connect the 3 clamps.
G9219A
2.INSTALL INVERTER TRAY BRACKET
G92A0A
3.INSTALL INVERTER RESERVE TANK ASSEMBLY
G9200
4.INSTALL INVERTER WITH CONVERTER ASSEMBLY
5.CONNECT WATER HOSE
82112
6.CONNECT NO. 2 ENGINE ROOM WIRE
G9221
7.REMOVE INVERTER COVER
82122
8.CONNECT NO. 2 ENGINE WIRE
G1148
9.CONNECT MOTOR CABLE
G2148
10.CONNECT GENERATOR CABLE
82164
11.CONNECT FRAME WIRE
12.CHECK HIGH VOLTAGE CABLE CONNECTION
G9221
13.INSTALL INVERTER COVER
82111
14.CONNECT ENGINE ROOM MAIN WIRE
G9214
15.INSTALL NO. 1 INVERTER BRACKET
G3834
16.INSTALL SERVICE PLUG GRIP
17.ADD COOLANT (for Inverter)
18.INSPECT FOR COOLANT LEAK (for Inverter)
51441
19.INSTALL NO. 1 ENGINE UNDER COVER
53289A
20.INSTALL RADIATOR SUPPORT OPENING COVER