33560
1.INSTALL SHIFT LOCK CONTROL UNIT ASSEMBLY
Connect the 3 connectors to shift lock control unit assembly.
Install the shift lock control unit assembly with the 3 nuts.
2.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
58810J
3.INSTALL CONSOLE BOX ASSEMBLY
55431B
4.INSTALL UPPER INSTRUMENT PANEL FINISH PANEL
5.INSTALL INTEGRATION CONTROL AND PANEL
6.INSTALL SHIFT LEVER KNOB
Using a die (M6 x P1.00 mm), clean the threads of the shift control unit assembly.
Turn the shift lever knob in the direction of the arrow in the illustration to install it.
Using a vernier caliper, adjust the height of the shift lever knob.
11.74 mm (0.462 in.)
| *a | Measuring Point |
Remove the protective tape around the shift lock control unit assembly.
7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64995
8.INSTALL DECK FLOOR BOX RH
64993
9.INSTALL REAR DECK FLOOR BOX
58412A
10.INSTALL NO. 2 DECK BOARD
58411A
11.INSTALL NO. 1 DECK BOARD
58410B
12.INSTALL DECK BOARD ASSEMBLY
13.INSPECT SHIFT LEVER
Turn the power switch on (READY).
Check that all available shift positions can be selected by moving the shift lever.
After the shift lock control unit assembly is replaced with a new one, perform the above operation. If this operation is not performed, moving the shift lever may not initially select shift positions.