Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR
RM2070E _54 Brake _061923 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0301687 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


PROCEDURE

Hide 84307 1.INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

a.

Install the spiral cable with sensor sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSTALLATION).

NOTICE:
·

Do not replace the spiral cable with sensor sub-assembly with the negative (-) auxiliary battery cable connected and the power switch on (IG).

·

Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the negative (-) auxiliary battery cable connected and the power switch on (IG).

·

Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.

·

Do not remove the steering angle sensor from the spiral cable.




Hide 3. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

Hide 84307 4.ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 45100 5.INSTALL STEERING WHEEL ASSEMBLY