Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD) › from 2014.11
RM2070E _54 Brake _061924 BRAKE SYSTEM (OTHER) _0301695 BRAKE PEDAL(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for LHD)  INSTALLATION  


PROCEDURE

Hide 47121 1.INSTALL BRAKE PEDAL PAD

Hide 47110 2.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

a.

Install the nut to the brake pedal support assembly.


b.

Install the brake pedal support assembly with the 4 nuts.

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


c.
C238452E01
0.222,0.67 0.394,0.819 0.172,0.149 10 *a

Install the brake pedal support assembly to the instrument panel reinforcement with the bolt.

Text in Illustration
*a Bolt Width

Bolt Variation Bolt Width
Bolt A 14 mm (0.551 in.)
Bolt B 12 mm (0.472 in.)

Torque:
for Bolt A : 14 N*m (140 kgf*cm, 10 ft.*lbf)
for Bolt B : 24 N*m (241 kgf*cm, 17 ft.*lbf)

HINT:

Two types of bolts each with a different torque specification are used.



d.

Engage the clamp to the brake pedal support assembly.


Hide 47264A 3.INSTALL PUSH ROD PIN

a.

Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal assembly.


b.

Install the push rod pin and a new clip to connect the push rod clevis to the brake pedal support assembly.


Hide 47101A 4.INSTALL BRAKE PEDAL RETURN SPRING

a.

Install the brake pedal return spring to the brake pedal support assembly and push rod pin.


Hide 84345 5.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 84340 6.INSTALL STOP LIGHT SWITCH ASSEMBLY

Hide 73900 8.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 9.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 58810J 10.INSTALL CONSOLE BOX ASSEMBLY

Hide 89650 11.INSTALL POWER STEERING ECU ASSEMBLY

Hide 12.INSPECT AND ADJUST BRAKE PEDAL

Hide 13. PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE

Hide 55606 14.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY