The following procedure is for the No. 1 parking brake cable assembly and No. 3 parking brake cable assembly.
Use the same procedure for the No. 3 parking brake cable assembly and No. 2 parking brake cable assembly.
46200
1.REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY (for LHD)
46200
2.REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY (for RHD)
46410
3.REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY (for LHD)
Remove the adjusting nut.
Pull up the parking brake pedal claw.
Remove the clip from the No. 1 parking brake cable assembly.
Remove the No. 1 parking brake cable assembly from the parking brake pedal assembly.
46410
4.REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY (for RHD)
Remove the adjusting nut.
Pull up the parking brake pedal claw.
Remove the clip from the No. 1 parking brake cable assembly.
Remove the No. 1 parking brake cable assembly from the parking brake pedal assembly.
46302
5.REMOVE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY
Separate the No. 3 parking brake cable assembly from the No. 1 parking brake pull rod sub-assembly as shown in the illustration.
| *1 | No. 1 Parking Brake Pull Rod Sub-assembly |
| *2 | No. 2 Parking Brake Cable Assembly |
| *3 | No. 3 Parking Brake Cable Assembly |
Separate the No. 2 parking brake cable assembly to remove the No. 1 parking brake pull rod sub-assembly.
Perform the same procedure as for the No. 3 parking brake cable assembly.
17410
6.REMOVE FRONT EXHAUST PIPE ASSEMBLY
58153
7.REMOVE FRONT NO. 2 FLOOR HEAT INSULATOR
Remove the 3 nuts and front No. 2 floor heat insulator.
57627A
8.REMOVE REAR FLOOR SIDE MEMBER COVER RH (for RH Side)
47612
9.SEPARATE PARKING BRAKE SHOE LEVER
46430
10.REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY
Remove the bolt and separate the No. 3 parking brake cable assembly from the parking plate sub-assembly.
Remove the 5 bolts and No. 3 parking brake cable assembly.