When an incorrect hybrid vehicle control ECU assembly is installed after the assist map has been recorded in the power steering ECU assembly, then DTC C1582/26 is stored because the data does not match the vehicle specifications.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1582/26 | Assist map number mismatch | ·
Power steering ECU assembly ·
CAN communication system ·
Hybrid vehicle control ECU assembly |
If the power steering ECU assembly has been replaced with a new one, perform assist map writing and rotation angle sensor value initialization torque sensor zero point calibration after performing the initialization of the torque sensor zero point value (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Using the GTS, check for DTCs and confirm that there are no problems in the CAN communication system (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM for with Central Gateway ECU or Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>DIAGNOSIS SYSTEM for without Central Gateway ECU).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output (w/ Central Gateway ECU) | B |
| DTC is output (w/o Central Gateway ECU) | C |
A
B
C
Check if a hybrid vehicle control ECU assembly that complies with the vehicle specifications is installed.
A hybrid vehicle control ECU assembly that complies with vehicle specifications is installed.
OK
NG