This DTC is stored when a communication error occurs between the radio and display receiver assembly and combination meter sub-assembly.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1324 | After the radio and display receiver assembly receives a registration information signal, which is sent by the combination meter sub-assembly when the power switch is turned on (ACC), 1 or more times, the radio and display receiver assembly does not receive the signal for 30 seconds or more. | ·
Combination meter sub-assembly ·
Radio and display receiver assembly ·
Harness or connector |
Disconnect the L169 radio and display receiver assembly connector.
Disconnect the L27 combination meter sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L169-3 (CNH1) - L27-28 (MSCH) | Always | Below 1 Ω |
| L169-4 (CNL1) - L27-29 (MSCL) | Always | Below 1 Ω |
| L27-28 (MSCH) - Body ground | Always | 10 kΩ or higher |
| L27-29 (MSCL) - Body ground | Always | 10 kΩ or higher |
| L27-28 (MSCH) - L27-29 (MSCL) | Always | 10 kΩ or higher |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L27-28 (MSCH) - Body ground | Always | Below 1 V |
| L27-29 (MSCL) - Body ground | Always | Below 1 V |
OK
NG
Remove the combination meter sub-assembly (See page Vehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 28 (MSCH) - 29 (MSCL) | Always | 108 to 132 Ω |
| *a | Component without harness connected
(Combination Meter Sub-assembly) |
OK
NG
Remove the radio and display receiver assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (CNH1) - 4 (CNL1) | Always | 108 to 132 Ω |
| *a | Component without harness connected
(Radio and Display Receiver Assembly) |
OK
NG
Replace the combination meter sub-assembly with a new or known good one (See page Vehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL).
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
OK
NG
Turn the power switch on (IG) and wait 30 seconds.
Operate the steering pad switch and check that the audio tab is displayed on the multi-information display in the combination meter sub-assembly and the audio system can be operated normally.
Audio system returns to normal.
OK
NG