This DTC is stored when a video or audio signal is interrupted due to auxiliary battery voltage input to the radio and display receiver assembly dropping temporarily.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B158F | A video or audio signal is interrupted when the auxiliary battery voltage drops | Radio and display receiver assembly |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Enter the "Vehicle Signal Check Mode" screen.
Refer to Check Vehicle Signal in Operation Check (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Radio and Display Type)>OPERATION CHECK).
Check the auxiliary battery voltage.
11 to 15.5 V
This display is updated once per second.
OK
NG
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Disconnect the L167 radio and display receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L167-4 (+B1) - Body ground | Power switch off | 11 to 14 V |
OK
NG