This DTC is stored when the parking assist ECU judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1694 | Maximum steering angle has not been memorized | ·
Steering angle setting ·
Parking assist ECU |
When the "System initializing" message is displayed on the radio and display receiver assembly*1 or navigation receiver assembly*2 after the auxiliary battery cable has been disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).
*1: for Radio and Display Type
*2: for Navigation Receiver Type
Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.
Steering angle setting (Diagnosis system) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DIAGNOSIS SYSTEM)
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1694 is output | A |
| DTCs are not output | B |
If DTC C1694 is output, perform steering angle setting again.
If DTC C1694 is still output after performing steering angle setting 3 times, replace the parking assist ECU.
A
B