The power steering system receives intelligent parking assist system information from the parking assist ECU via CAN communication. This DTC is stored if the parking assist ECU receives abnormal signals from the power steering ECU assembly.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C164A | EPS communication malfunction | ·
Parking assist ECU ·
Power steering system ·
Power steering ECU assembly |
When the "System initializing" message is displayed on the radio and display receiver assembly*1 or navigation receiver assembly*2 after the auxiliary battery cable has been disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).
If initialization is necessary while performing an inspection, perform initialization first and then proceed to the next step.
*1: for Radio and Display Type
*2: for Navigation Receiver Type
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C164A is output | A |
| DTCs are not output | B |
If the DTC is not output again when rechecking for DTCs, it may have been stored due to a temporary communication problem between the parking assist ECU and power steering ECU.
If DTC C164A is output frequently, duplicate the problem symptoms and perform the inspection again, even if the DTC is not output when rechecking for DTCs (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING).
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
Replace the parking assist ECU (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST ECU>REMOVAL).
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C164A is output | A |
| DTCs are not output | B |
A
B
Check for power steering system DTCs.
Power steering System (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| Power steering system DTC is output | B |
A
B