This DTC is stored when the parking assist ECU judges as a result of its self check that the vehicle information received from the main body ECU (multiplex network body ECU) via CAN communication and the vehicle information stored in the rear television camera assembly do not match.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C168D | Vehicle Information is Unmatched | ·
Rear television camera assembly optical axis adjustment (back camera position setting) ·
Steering angle setting ·
Parking assist ECU |
When "System initializing" is displayed on the multi-display after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).
Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.
Rear television camera assembly optical axis adjustment (back camera position setting) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).
Steering angle setting (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DIAGNOSIS SYSTEM).
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check that no DTCs are output (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
If DTC C168D is output, perform the procedure to allow the intelligent parking assist ECU to store the vehicle information again.
If DTC C168D is still output after performing the procedure to make the intelligent parking assist ECU store the vehicle information 3 times, replace the intelligent parking assist ECU.
| Result | Proceed to |
|---|---|
| DTC C168D is output | A |
| DTC C168D is not output | B |
A
B