The main body ECU (multiplex network body ECU) receives switch signals from the multiplex network master switch assembly and driver door key cylinder switch signals from the front door lock assembly LH. The main body ECU (multiplex network body ECU) activates the door lock motor on each door according to these signals.
Check door lock operation (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>OPERATION CHECK).
| Result | Proceed to |
|---|---|
| All doors cannot be locked through multiplex network master switch assembly | A |
| All doors cannot be locked through driver door key cylinder | B |
A
B
Clear the DTC (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs.
DTC B1206 is not output.
OK
NG
Replace the multiplex network master switch assembly (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW MASTER SWITCH>REMOVAL).
NEXT
Check that all doors can be locked and unlocked by using the multiplex network master switch assembly (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>OPERATION CHECK).
All doors can be locked and unlocked with the multiplex network master switch assembly.
OK
NG
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Door Key SW-Lock | Driver door key-linked lock/unlock switch lock signal/ON or OFF | ON: Driver door key cylinder turned to lock position
OFF: Driver door key cylinder not turned to lock position |
- |
| Door Key SW-Unlock | Driver door key-linked lock/unlock switch unlock signal/ON or OFF | ON: Driver door key cylinder turned to unlock position
OFF: Driver door key cylinder not turned to unlock position |
- |
The GTS indicates ON or OFF according to the key cylinder operation shown in the table.
OK
NG
for LHD:
Remove the front door lock assembly LH (See page Vehicle Interior>DOOR LOCK>FRONT DOOR LOCK>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 9 (L) - 7 (E) | Turned to lock | Below 1 Ω |
| 9 (L) - 7 (E) | Not turned | 10 kΩ or higher |
| 10 (UL) - 7 (E) | Turned to unlock | Below 1 Ω |
| 10 (UL) - 7 (E) | Not turned | 10 kΩ or higher |
| *a | Component without harness connected
(Front Door Lock Assembly LH) |
| *b | Unlock |
| *c | Lock |
for RHD without Double Locking System:
Remove the front door lock assembly RH (See page Vehicle Interior>DOOR LOCK>FRONT DOOR LOCK>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 (L) - 8 (E) | Turned to lock | Below 1 Ω |
| 6 (L) - 8 (E) | Not turned | 10 kΩ or higher |
| 5 (UL) - 8 (E) | Turned to unlock | Below 1 Ω |
| 5 (UL) - 8 (E) | Not turned | 10 kΩ or higher |
| *a | Component without harness connected
(Front Door Lock Assembly RH) |
| *b | Unlock |
| *c | Lock |
for RHD with Double Locking System:
Remove the front door lock assembly RH (See page Vehicle Interior>DOOR LOCK>FRONT DOOR LOCK>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 (L) - 8 (E) | Turned to lock | Below 1 Ω |
| 6 (L) - 8 (E) | Not turned | 10 kΩ or higher |
| 5 (UL) - 8 (E) | Turned to unlock | Below 1 Ω |
| 5 (UL) - 8 (E) | Not turned | 10 kΩ or higher |
| *a | Component without harness connected
(Front Door Lock Assembly RH) |
| *b | Unlock |
| *c | Lock |
OK
NG
Disconnect the main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O8-9 (L) - L7-11 (L2) | Always | Below 1 Ω |
| O8-10 (UL) - L7-12 (UL2) | Always | Below 1 Ω |
| O8-7 (E) - Body ground | Always | Below 1 Ω |
| L7-11 (L2) - Body ground | Always | 10 kΩ or higher |
| L7-12 (UL2) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N8-6 (L) - L7-11 (L2) | Always | Below 1 Ω |
| N8-5 (UL) - L7-12 (UL2) | Always | Below 1 Ω |
| N8-8 (E) - Body ground | Always | Below 1 Ω |
| L7-11 (L2) - Body ground | Always | 10 kΩ or higher |
| L7-12 (UL2) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N8-6 (L) - L7-11 (L2) | Always | Below 1 Ω |
| N8-5 (UL) - L7-12 (UL2) | Always | Below 1 Ω |
| N8-8 (E) - Body ground | Always | Below 1 Ω |
| L7-11 (L2) - Body ground | Always | 10 kΩ or higher |
| L7-12 (UL2) - Body ground | Always | 10 kΩ or higher |
OK
NG