The combination meter sub-assembly receives signals from this circuit to adjust the illumination of the meter. The combination meter sub-assembly sets the illumination level based on the user operation of the light control rheostat switch.
The meter illumination level can be adjusted by operating the hazard warning signal switch assembly (light control rheostat switch).
The meter illumination dims when the light control switch is turned to the tail, head, or AUTO position at night.
Setting the meter illumination to maximum brightness cancels the above dimming of the meter illumination.
Before starting the following inspection, check if the lighting system outputs DTCs (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR).
Check if CAN communication DTCs are output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM).(w/ Central Gateway ECU)
Check if CAN communication DTCs are output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>DIAGNOSIS SYSTEM).(w/o Central Gateway ECU)
| Result | Proceed to |
|---|---|
| CAN communication DTCs are not output. | A |
| CAN communication DTCs are output. (w/ Central Gateway ECU) | B |
| CAN communication DTCs are output. (w/o Central Gateway ECU) | C |
A
B
C
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Illumination Rate Info | Illumination rate information/0 ms. to 99.99 ms. | Value output according to ambient light level | - |
| Result | Proceed to |
|---|---|
| The output value changes according to the ambient light level (w/o Multi-information display). | A |
| The output value changes according to the ambient light level (w/ Multi-information display). | B |
| The output value does not change according to the ambient light level. | C |
A
B
C
Replace the meter circuit plate with a new or a known good one (See page Vehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>DISASSEMBLY).
The operation of the combination meter sub-assembly returns to normal.
OK
NG
Replace the combination meter sub-assembly with a new or a known good one (See page Vehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL).
The operation of the combination meter sub-assembly returns to normal.
OK
NG