Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG CUT-OFF SWITCH › from 2016.05
RM2070E _58 Vehicle Interior _061942 SUPPLEMENTAL RESTRAINT SYSTEMS _0301809 AIRBAG CUT-OFF SWITCH A

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG CUT-OFF SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the front passenger side of RHD and LHD vehicles.

·

The procedures listed below are for the front passenger side of an LHD vehicle.



PROCEDURE

Hide 69065A 1.INSTALL AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

a.

Engage the 2 claws to install the airbag cut off switch cylinder sub-assembly.


Hide 55435A 2.INSTALL INSTRUMENT PANEL FINISH PANEL END RH

Hide 3.INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 62311B 5.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

Hide 62111C 6.INSTALL COWL SIDE TRIM BOARD RH

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).


Hide 67911B 7.INSTALL FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).


Hide 8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).