Home › Vehicle Exterior › WIPER / WASHER › WIPER ECU › 2014.11–2016.05
RM2070E _59 Vehicle Exterior _061952 WIPER / WASHER _0301906 WIPER ECU A

WIPER / WASHER  WIPER ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55440D 9.REMOVE INSTRUMENT PANEL BOX ASSEMBLY

Hide 10.REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 11.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)

Hide 12.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for Navigation Receiver Type)

Hide 85940 13.REMOVE WINDSHIELD WIPER RELAY ASSEMBLY

a.
E250232

Disconnect the connector.


b.

Remove the bolt and windshield wiper relay assembly.