When DTCs for the following systems are stored, this DTC is stored simultaneously.
Lane departure alert system
CAN communication system
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B124B | Malfunction in automatic high beam system | ·
Lane departure alert system ·
Lane departure warning camera ·
Main body ECU (multiplex network body ECU) ·
CAN communication system ·
Electronically controlled brake system ·
SFI system |
Confirm that the CAN communication system is not malfunctioning before performing the following inspection (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING) (w/o Central Gateway ECU) (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING) (w/ Central Gateway ECU).
Clear the DTCs (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR).
DTC B124B is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| Lane departure alert system DTCs are not output | A |
| Lane departure alert system DTCs are output | B |
| CAN communication system DTCs are output (w/o Central Gateway ECU) | C |
| CAN communication system DTCs are output (w/ Central Gateway ECU) | D |
A
B
C
D
Check if a lane departure alert system warning message is displayed on the multi-information display.
No lane departure alert system warning message are displayed.
OK
NG