Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
81150
1.INSTALL HEADLIGHT ASSEMBLY
Connect each connector.
Engage the clamp.
Engage the claw.
Install the headlight assembly with the bolt and 2 screws.
2.INSTALL FRONT BUMPER ASSEMBLY
3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64995
4.INSTALL DECK FLOOR BOX RH
64993
5.INSTALL REAR DECK FLOOR BOX
58411A
6.INSTALL NO. 1 DECK BOARD
58412A
7.INSTALL NO. 2 DECK BOARD
58410B
8.INSTALL DECK BOARD ASSEMBLY
9.ADJUST HEADLIGHT AIMING
10.ADJUST FOG LIGHT AIMING (w/ Fog Light)