Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY › 2013.08–2014.11
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301909 HEADLIGHT ASSEMBLY A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 81150 1.INSTALL HEADLIGHT ASSEMBLY

a.

Connect each connector.


b.

Engage the clamp.


c.
E222902

Engage the claw.


d.

Install the headlight assembly with the bolt and 2 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 2.INSTALL FRONT BUMPER ASSEMBLY

Hide 3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 10.ADJUST FOG LIGHT AIMING (w/ Fog Light)