Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER › 2017.12–2020.08
RM2070E _58 Vehicle Interior _061946 HEATING / AIR CONDITIONING _0301846 CONDENSER A

HEATING / AIR CONDITIONING  CONDENSER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (for HFC-134a(R134a))

Hide 3. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (for HFO-1234yf(R1234yf))

Hide 9.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 10.REMOVE FRONT BUMPER ASSEMBLY

Hide G9229A 12.DISCONNECT NO. 5 INVERTER COOLING HOSE

a.
E223849

Using pliers, grip the claws of the clip and slide the clip to disconnect the No. 5 inverter cooling hose.

NOTICE:
·

After disconnecting the No. 5 inverter cooling hose, immediately seal the openings of the hose and the condenser assembly with receiver and hybrid radiator assembly using vinyl tape to prevent entry of foreign matter.

·

Do not apply excessive force to the No. 5 inverter cooling hose.

·

Prepare a drain pan or cloth in case the coolant leaks.




Hide G9225K 13.DISCONNECT NO. 1 INVERTER COOLING HOSE

a.
E223850

Using pliers, grip the claws of the clip and slide the clip to disconnect the No. 1 inverter cooling hose.

NOTICE:
·

After disconnecting the No. 1 inverter cooling hose, immediately seal the openings of the hose and the condenser assembly with receiver and hybrid radiator assembly using vinyl tape to prevent entry of foreign matter.

·

Do not apply excessive force to the No. 1 inverter cooling hose.

·

Prepare a drain pan or cloth in case the coolant leaks.




Hide 88711 14.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

a.
E223847

Remove the bolt and disconnect the No. 1 cooler discharge hose.


b.

Remove the O-ring from the No. 1 cooler discharge hose.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



Hide 88710E 15.DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY

a.
E223848

Remove the bolt and disconnect the air conditioner tube and accessory assembly.


b.

Remove the O-ring from the air conditioner tube and accessory assembly.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



Hide 53208A 16.REMOVE HOOD LOCK SUPPORT SUB-ASSEMBLY

Hide 88450 18.REMOVE CONDENSER ASSEMBLY WITH RECEIVER

a.
E224557

Disengage the 2 guides and remove the condenser assembly with receiver and hybrid radiator assembly as shown in the illustration.


b.
E223852

Remove the 4 bolts and hybrid radiator assembly from the condenser assembly with receiver.