Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY › from 2019.03
RM2070E _59 Vehicle Exterior _061950 DOOR / HATCH _0301878 HOOD LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 53630 1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)

a.

Pass the hood lock control cable assembly into the engine compartment.


b.

Pass the cable through the upper radiator support.


c.

Engage 6 clamps and the 2 grommets.


d.

Connect the hood lock control cable assembly.


Hide 53630 2.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)

a.

Pass the hood lock control cable assembly into the engine compartment.


b.

Pass the cable through the upper radiator support.


c.

Engage 5 clamps and the 2 grommets.


d.

Connect the hood lock control cable assembly.


Hide 53601 3.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.

Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.


Hide 53601 4.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 55606 5.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

Hide 62112A 6.INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)

Hide 67914 7.INSTALL FRONT DOOR SCUFF PLATE LH (for LHD)

Hide 55606 8.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>INSTALLATION).


Hide 62111C 9.INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION)


Hide 67911B 10.INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION)


Hide 53876A 11.INSTALL FRONT FENDER LINER LH (for LHD)

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Exterior>WIPER / WASHER>WASHER MOTOR(for Front Side)>INSTALLATION).


Hide 75860A 12.INSTALL BODY ROCKER PANEL MOULDING ASSEMBLY LH (for LHD)

Hide 53875A 14.INSTALL FRONT FENDER LINER RH (for RHD)

Hide 75850A 15.INSTALL BODY ROCKER PANEL MOULDING ASSEMBLY RH (for RHD)

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>ROCKER PANEL MOULDING>INSTALLATION)