Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Smart Key System)

ENGINE IMMOBILISER SYSTEM (w/ Smart Key System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use this procedure to troubleshoot the engine immobiliser system.
  1. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT AUXILIARY BATTERY VOLTAGE
    1. Measure the auxiliary battery voltage with the power switch off.

      Standard Voltage:
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

      HINT:
      A simple method to determine whether the auxiliary battery is discharged is to operate the horn.


    NEXT


    3.TURN POWER SWITCH ON (IG)

      HINT:
      If the power switch cannot be turned on (IG), communication with the Techstream can be confirmed by connecting the Techstream to the vehicle and turning a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and vehicle begins.


    NEXT


    4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the Techstream to check if the CAN communication system is functioning normally (Click here).

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
    1. Use the Techstream to check if the LIN communication system is functioning normally (Click here).

      Result:
      Result
      Proceed to
      LIN DTC is not output
      A
      LIN DTC is output
      B



    B.
    GO TO LIN COMMUNICATION SYSTEM (Click here)
    A


    6.CHECK FOR DTC*
    1. Check for DTCs and make a note of any codes that are output (Click here).

    2. Based on the DTCs output above, proceed to each diagnostic procedure.

      Result:
      Result
      Proceed to
      DTC is not output
      A
      Hybrid control system DTC is output
      B
      Steering lock system DTC is output
      C
      Engine immobiliser system DTC is output
      D



    B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)

    C.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)

    D.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    7.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result:
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to step 9
    A


    8.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Data List / Active Test (Click here)

    2. Terminals of ECU (Click here)


    NEXT


    9.REPAIR OR REPLACE

      NEXT


      10.CHECK FOR DTC*
      1. Clear the DTCs (Click here).

      2. Check for DTCs (Click here).

        HINT:
        Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure (Click here).

        Result:
        Result
        Proceed to
        DTC is not output
        A
        Engine immobiliser system DTC is output
        B



      B.
      GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
      A

      END