ELECTRONICALLY CONTROLLED BRAKE SYSTEM > Slip Indicator Light Remains ON |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| A | |
| 2.CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED |
Check if the skid control ECU (brake booster with master cylinder assembly) connector is securely connected.
|
| ||||
| OK | |
| 3.CHECK AUXILIARY BATTERY |
Check the auxiliary battery voltage.
| Tester Connection | Condition | Specified Condition |
| Auxiliary battery | Ignition switch ON (IG) | 11 to 14 V |
| Auxiliary battery | Ignition switch ON (READY) | 11 to 15.5 V |
|
| ||||
| OK | |
| 4.INSPECT COMBINATION METER ASSEMBLY |
Perform the Active Test of the combination meter assembly (meter CPU) using the Techstream (Click here).
Check the combination meter assembly.
|
| ||||
| OK | ||
| ||