ELECTRONICALLY CONTROLLED BRAKE SYSTEM > Slip Indicator Light does not Come ON |
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (SLIP INDICATOR LIGHT) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Select the Active Test on the Techstream (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Slip Indicator Light | Slip indicator light | Indicator light ON/OFF | Observe combination meter assembly |
Check that the slip indicator light on the combination meter assembly turns on or off in accordance with Techstream operation.
|
| ||||
| OK | ||
| ||
| 3.INSPECT COMBINATION METER ASSEMBLY |
Turn the ignition switch off.
Perform the Active Test of the combination meter assembly (meter CPU) using the Techstream (Click here).
Check the combination meter assembly.
|
| ||||
| OK | ||
| ||