Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

ELECTRONICALLY CONTROLLED BRAKE SYSTEM > Brake Control Warning Light does not Come ON

for Preparation Click here


DESCRIPTION

The skid control ECU (brake booster with master cylinder assembly) is connected to the combination meter assembly via CAN communication.

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake booster with master cylinder assembly), perform initialization and calibration of the linear solenoid valve (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication system DTCs are output (Click here).

    Result:

    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM (BRAKE WARNING LIGHT / YELLOW (MINOR MALFUNCTION))
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON (IG).

  1. Select the Active Test on the Techstream (Click here).

    ABS/VSC/TRAC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    ECB* Warning Light
    Brake warning light / yellow (minor malfunction)
    Warning light ON/OFF
    Observe combination meter assembly
    *: Electronically Controlled Brake System

  1. Check that the brake warning light / yellow (minor malfunction) on the combination meter assembly turns on or off in accordance with Techstream operation.

    OK:
    The brake warning light / yellow (minor malfunction) turns on or off in accordance with Techstream operation.

    HINT:
    If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).



NG
Go to step 3
OK

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY (Click here)  

3.INSPECT COMBINATION METER ASSEMBLY
  1. Turn the ignition switch off.

  1. Perform the Active Test of the combination meter assembly (meter CPU) using the Techstream (Click here).

  1. Check the combination meter assembly.

    OK:
    The brake warning light / yellow (minor malfunction) turns on or off in accordance with Techstream operation.

    HINT:
    If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY (Click here)