SEAT BELT WARNING SYSTEM > Driver Side Seat Belt Warning Light does not Operate |

| 1.CHECK DTC OUTPUT (AIRBAG SYSTEM) |
Clear DTCs (Click here).
Recheck for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch ON (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / SRS Airbag / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Left Side Buckle SW | LH buckle switch/Unset, Set or NG | Unset: Seat belt not fastened Set: Seat belt fastened NG: Data not determined | - |
| Result | Proceed to |
| Unset or Set is displayed on the Techstream screen according to the driver seat belt condition | A |
| Unset or Set is not displayed normally on the Techstream screen according to the driver seat belt condition | B |
| NG is displayed on the Techstream screen | C |
|
| ||||
|
| ||||
| A | |
| 3.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
Replace the main body ECU (multiplex network body ECU) (Click here).
| NEXT | |
| 4.CHECK SEAT BELT WARNING LIGHT |
Check the operation of the seat belt warning light (Click here).
|
| ||||
| OK | ||
| ||