Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use this procedure to troubleshoot the seat belt warning system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble (Click here).


    NEXT


    3.INSPECT AUXILIARY BATTERY VOLTAGE
    1. Measure the auxiliary battery voltage with ignition switch off.

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.


    NEXT


    4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the Techstream to check if the CAN communication system is functioning normally (Click here).

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK DTC OUTPUT (AIRBAG SYSTEM)*
    1. Clear DTCs (Click here).

    2. Recheck for DTCs (Click here).

      Result:
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    GO TO AIRBAG SYSTEM (Click here)
    A


    6.CHECK DTC OUTPUT (OCCUPANT CLASSIFICATION SYSTEM)*
    1. Clear DTCs (Click here).

    2. Recheck for DTCs (Click here).

      Result:
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    GO TO OCCUPANT CLASSIFICATION SYSTEM (Click here)
    A


    7.CHECK COMBINATION METER ASSEMBLY
    1. Check that the operation of the speedometer, shift indicator and brake warning light on the combination meter assembly.

      OK:
      The speedometer, shift indicator and brake warning light on the combination meter assembly operate normally.



    NG.
    GO TO METER / GAUGE SYSTEM (Click here)
    OK


    8.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result:
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to step 10
    A


    9.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Data List / Active Test (Click here)

    2. Terminals of ECU (Click here)

    3. On-vehicle Inspection (Click here)


    NEXT


    10.REPAIR OR REPLACE

      NEXT


      11.CONFIRMATION TEST

        NEXT

        END