Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM

STEERING LOCK SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the steering lock system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer and confirm the problem (Click here).


    NEXT


    3.CHECK AUXILIARY BATTERY VOLTAGE

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

      HINT:
      A simple method to determine whether the auxiliary battery is depleted is to operate the horn.


    NEXT


    4.CHECK DTC*
    1. Check for DTCs and make a note of any codes that are output (Click here).

      HINT:
      When DTCs indicating CAN and/or LIN communication system malfunctions are output, repair the CAN and/or LIN communication systems before performing diagnosis (Click here for CAN and/or Click here for LIN).


      Result:

      Result
      Proceed to
      DTC is not output. (Problem symptom cannot be confirmed or reproduced.)
      A
      DTC is not output. (Problem symptom can be confirmed and reproduced.)
      B
      Steering lock system DTC is output.
      C

      HINT:
      1. When steering lock system DTCs are output, refer to Diagnostic Trouble Code Chart (Click here).
      2. The steering lock system does not store past DTCs.



    B.
    Go to step 6

    C.
    Go to step 8
    A


    5.SYMPTOM SIMULATION
    1. Proceed to How to Proceed with Troubleshooting (Click here).


    NEXT


    6.PROBLEM SYMPTOMS TABLE
    1. Proceed to Problem Symptoms Table (Click here).

      Result:

      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table.
      A
      Fault is listed in Problem Symptoms Table.
      B



    B.
    Go to step 8
    A


    7.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Proceed to Data List / Active Test (Click here).

    2. Proceed to Terminals of ECU (Click here).


    NEXT

    Go to step 9


    8.CIRCUIT INSPECTION*

      NEXT


      9.REPAIR OR REPLACE

        NEXT


        10.CHECK DTC AGAIN*
        1. Clear the DTCs (Click here).

        2. Check for DTCs and make a note of any codes that are output (Click here).

          HINT:
          Perform the DTC output confirmation operation.


          Result:

          Result
          Proceed to
          DTC is not output.
          A
          Steering lock system DTC is output.
          B



        B.
        GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
        A

        END