DTC B2325 LIN Communication Bus Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2325 | Main body ECU (multiplex network body ECU) detects errors in communication with the ECUs connected to the door bus lines 3 times in a row. |
|

| 1.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Remove the instrument panel junction block assembly (Click here).
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3B-12 (LIN2) - MB-16 (LIN2) | Always | Below 1 Ω |
| 3A-4 (LIN2) - MB-16 (LIN2)* | Always | Below 1 Ω |
| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | *b | Component without harness connected (Instrument Panel Junction Block Assembly) |
| *c | Component without harness connected (Instrument Panel Junction Block Assembly) | - | - |
Install the main body ECU (multiplex network body ECU) to the instrument panel junction block assembly.
Install the instrument panel junction block assembly (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK - EACH ECU) |
Disconnect the Q3 sliding roof ECU (sliding roof drive gear assembly) connector*.
Disconnect the J3 power window regulator motor (for driver door) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3B-12 (LIN2) - J3-9 (LIN) | Always | Below 1 Ω |
| 3A-4 (LIN2) - Q3-11 (MPX1)* | Always | Below 1 Ω |
| J3-9 (LIN) - Body ground | Always | 10 kΩ or higher |
| Q3-11 (MPX1) - Body ground* | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK DTC OUTPUT (POWER WINDOW REGULATOR MOTOR ASSEMBLY (for DRIVER DOOR)) |
Reconnect the 3B and 3A instrument panel junction block assembly connector.
Reconnect the Q3 sliding roof ECU (sliding roof drive gear assembly) connector*.
Clear the DTC (Click here).
After 10 seconds have elapsed, check if the trouble occurs again.
Check for DTCs again.
| Result | Proceed to |
| DTC B2325 is output (w/ Sliding Roof System) | A |
| DTC B2325 is output (w/o Sliding Roof System) | B |
| DTC B2325 is not output | C |
|
| ||||
|
| ||||
| A | |
| 4.CHECK DTC OUTPUT (SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)) |
Reconnect the J3 power window regulator motor (for driver door) connector.
Disconnect the Q3 sliding roof ECU (sliding roof drive gear assembly) connector.
Clear the DTC (Click here).
After 10 seconds have elapsed, check if the trouble occurs again.
Check for DTCs again.
| Result | Proceed to |
| DTC B2325 is output | A |
| DTC B2325 is not output | B |
|
| ||||
| A | ||
| ||