Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Hazard Warning Switch Circuit

for Preparation Click here


DESCRIPTION

The combination meter assembly receives the hazard warning signal switch ON signal and controls the operation of the hazard warning lights.

WIRING DIAGRAM


E224262E06


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Data List.

  1. Read the display on the Techstream.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Hazard Flasher Switch
    Hazard switch signal/ON or OFF
    ON: Hazard switch on
    OFF: Hazard switch off
    -

    OK:
    Normal conditions listed above are displayed.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
  1. Remove the hazard warning signal switch assembly (Click here).

  1. Inspect the hazard warning signal switch assembly (Click here).



NG
REPLACE HAZARD WARNING SIGNAL SWITCH ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)
  1. Disconnect the G3 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G2-4 (TB) - G3-3 (HAZ)
    Always
    Below 1 Ω
    G2-4 (TB) - Body ground
    Always
    10 kΩ or higher
    G2-1 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)