Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM

DTC    C1694    Steering Angle Initialization Incomplete

for Preparation Click here


DESCRIPTION

This DTC is stored when the parking assist ECU judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).

DTC No.
DTC Detection Condition
Trouble Area
C1694
Maximum steering angle has not been memorized
  1. Steering angle setting
  2. Parking assist ECU

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" message is displayed on the navigation receiver assembly after the battery terminal disconnected, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (Click here).

1.ADJUST SETTINGS (STEERING ANGLE SETTING)
  1. Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.

    1. Steering angle setting (Diagnosis system) (Click here)


NEXT


2.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC C1694 is output
    A
    No DTC is output
    B

    HINT:
    1. If DTC C1694 is output, perform the steering angle setting again.
    2. If DTC C1694 is still output after performing the steering angle setting 3 times, replace the parking assist ECU.



B
END
A

REPLACE PARKING ASSIST ECU (Click here)