Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM

DTC    C164A    EPS Communication Malfunction

for Preparation Click here


DESCRIPTION

The power steering system receives intelligent parking assist system information from the parking assist ECU via CAN communication. This DTC is stored if the parking assist ECU receives abnormal signals from the power steering ECU.

DTC No.
DTC Detection Condition
Trouble Area
C164A
EPS communication malfunction
  1. Parking assist ECU
  2. Power steering system
  3. Power steering ECU

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" message is displayed on the navigation receiver assembly after the battery terminal disconnected, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (Click here).
  3. If initialization is necessary while performing an inspection, perform initialization first and then proceed to the next step.

1.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC C164A is output
    A
    No DTC is output
    B

    HINT:
    1. If the DTC is not output again when rechecking for DTCs, it may have been stored due to a temporary communication problem between the parking assist ECU and power steering ECU.
    2. If DTC C164A is output frequently, duplicate the problem symptoms and perform the inspection again, even though the DTC is not output when rechecking for DTCs (Click here).



B
USE SIMULATION METHOD TO CHECK (Click here)
A


2.REPLACE PARKING ASSIST ECU
  1. Replace the parking assist ECU (Click here).


NEXT


3.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC C164A is output
    A
    No DTC is output
    B



B
END
A


4.CHECK DTC OUTPUT (POWER STEERING SYSTEM)
  1. Check for power steering system DTCs.

    Result:
    Result
    Proceed to
    Power steering system DTC is output
    A
    Power steering system DTC is not output
    B



B
REPLACE POWER STEERING ECU ASSEMBLY (Click here)
A

GO TO POWER STEERING SYSTEM (Click here)